Omega Vehicle Security CN3271 Series Manuale Utente Scaricare il pdf (Pagina 29)

Appendix A.2

Loading Default Configuration ParametersLoading Default Configuration Parameters

Loading Default Configuration Parameters

The configuration parameters can be loaded with

predetermined default values. These are the

settings loaded into the instrument prior to

shipment from the factory. To load the default

values proceed as follows:

a) Internal switch V101 must be open.

b) The upper display will show:

c) Press the key; the lower display will show

the firmware version.

d) Still holding the key, press the key; the

display will show:

e) Press the key to select Table 1 (Euro-

pean) or Table 2 (American) default

parameters; the display will show:

f) Press the FUNC key; the display will show:

This indicates that the loading procedure has

been initiated. After about 3 seconds the

procedure is complete and the instrument reverts

to the “COnF” display. The following is a list of the

default configuration parameters loaded during

the procedure:

LHL-A-NEUTRO.pmd 19/04/2004, 15.282

1 2 ... 24 25 26 27 28 29 30 31 32 33

Nessun commento

Omega Vehicle Security CN3271 Series Manuale Utente Pagina 29